Support Center

Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB


Alexander Röder May 09, 2017 05:40PM CEST


I have setup Lemur on a Lenovo Tablet. I have connected it via Cable to an iMac with horndis. So far so good... iMac connection is there, I can communicate from Lemur editor to Lemur on tablet.

So I setup Lemur daemon successfully so it connects to the tablet. Setup Daemon 0 and also Daemon 1.

Now I go to Cubase device setup / generic remote and setup to daemon 0 in and out. But Cubase receives nothing. I have setup metagrid on tablet and load the Cubase-template in generic device setup, also nothing happens. Cubase doesn´t receive any message.

So what is wrong ?

Up -1 rated Down
Liine Support May 18, 2017 02:26PM CEST Liine Agent
Use a MIDI Monitor to make sure MIDI data is getting from the Lemur app to the computer, this one is a good tool:

If the data is going through, then you need to consult the Cubase documentation regarding external MIDI control.

If the data is not going through, the problem is with Lemur and the Lemur Daemon configuration.

This question has received the maximum number of answers.
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found