Support Center

Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB

Program change "0" only sends once upon opening project

Christopher Hoffman Nov 14, 2017 07:12PM CET

So my buddy helped me set up 64 custom buttons to send program changes to my master controller. It works like a charm, except on program change 0 (zero), which on Roland, is program change "1".

In this case, pressing my Button one will send a program change of zero, but only once, until the lemur is closed and reopened. All the other buttons 2-64 (program change 1-63) work as they should. The scale used for program change "0", is "0 to 0". None of conditions (the little check boxes) for this midi message to be sent fix the issue. Any ideas how to fix this?


Up 0 rated Down
Christopher Hoffman Nov 21, 2017 07:04PM CET
Nobody? I emailed this question to Liine two weeks ago. No response. Hmmm.

This question has received the maximum number of answers.
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found