Support Center

Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB


Todd May 28, 2018 03:26AM CEST

Upgraded to an SSD with a clean install of Windows 10. Ever since then the daemon will not open. I’m getting the error “Unable to use Direct3D, please install DirectX (error0x8876086A backbuffer 1920x 1080:22 window0x00010010). I’ve completed every known troubleshooting step on this site, from Microsoft, and have the daemon working fine on a secondary computer that was just reimaged with the same Windows disk. I’m out of ideas. Short of a complete reformat or ditching my SSD is there any workaround?

Up 0 rated Down
Gerd Oct 06, 2018 01:19PM CEST
Have the same problem.
it occured from one day to another without making changes at all so i suspect windows update to caused the problem!
is there a solution?

Post Your Public Answer

Your name (required)
Your email address (required)
Answer (required)
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found